User and Machine settings
Here you can change some personal or machine settings.
Save your changes | |
Choose how the units should be displayed | |
Change your language | |
Pdf layers import | |
Choose your lid camera | |
Choose a Home Position type | |
Custom home position | |
Custom home position | |
Exhaust pre run time | |
Exhaust post run time | |
Check exhaust during process | |
Air assist – Gas kit installed | |
Choose a lens | |
Print and cut | |
Enable the vision camera |
Vision camera calibration
- Enable the Vision camera by clicking on the switch.
- Click save to continue the process. (Settings must be saved before calibration is performed)
- If your queue isn’t empty you will get a pop-up that your queue will get cleared.
- Enter Parameter to cut through your calibration (eg. Power: 10%; Velocity: 1%)
- Move the laserpointer to the spot where you want to cut the calibration circles.
- Click on “Queue calibration job” to start the calibration.
- Switch to the Produce Screen and start the job
Note: The camera detects the offset values and adds them to the settings.
Updated on 15. September 2021